Crochet Snowflake Sifnos
Give your Christmas tree a heartfelt touch of homemade with these delicate crocheted snowflakes. So easy and beautiful!
The size depends on the thread and the hook you’ll choose to use. However, just to give you an idea of this snowflake’s size, with cotton thread size 10 and a 2 mm crochet hook, it’s going to measure 10 cm (about 4 inches) in diameter. You can use heavier thread and bigger hook, or thinner thread and smaller hook and you’ll have a bigger or smaller motif. You will also need a needle to weave in loose ends and a pair of scissors.
If you want to block your snowflakes you will also need white pva glue, stainless steel pins (or toothpicks), plastic wrap and some kind of foam/blocking board.
AD-Free, Print Ready PDF version of this pattern is available here.
Make a magic ring.
- Round 1: Ch 3 (counts as dc), 23 dc in ring, pull the thread end to tighten the ring and join with sl st in 3rd ch of first ch3.
- Round 2: Ch 3 (counts as dc), (1 dc, ch 3, 2 dc) in same dc, * ch 7, skip 3 dc, in next dc work (2 dc, ch 3, 2 dc); repeat from * 5 times, ch 7, skip 3 dc, join with sl st in 3rd ch of first ch3.
- Round 3: Sl st in next dc and in ch-3 sp, ch 3 (counts as dc), (1 dc, ch 3, 2 dc) in same sp, * ch 7, in next ch-3 sp work (2 dc, ch 3, 2 dc); repeat from * 5 times, ch 7, join with sl st in 3rd ch of first ch3.
- Round 4: Sl st in next dc and in ch-3 sp, ch 4 (counts as tr), (2 tr, ch 8, 3 tr) in same sp, ch 5, * sc in ch-7 sp of both Round 3 and Round 2, ch 5, in next ch-3 sp work (3 tr, ch 8, 3 tr), ch 5; repeat from * 5 times, sc in last ch-7 sp of both Round 3 and Round 2, ch 5, join with sl st in 4th ch of first ch4.
Fasten off and weave in loose ends.
Another photo of the same motif
Print out this blocking template. It will help you make your snowflakes symmetrical. Tape it on your blocking board and then cover it with plastic wrap.
Prepare a mix of equal amounts of white craft glue and water, or use your preferred stiffening solution.
Soak the snowflake in the solution, squeeze out the excess and spread out the snowflake on the plastic wrap-covered pinning board, having right side facing up. Use stainless steel pins and start by pinning the center. Work your way out pinning as you go until you reach the desired look. While it is still wet, you can sprinkle glitter and make it sparkly. Let dry completely. Remove from the board.
To hang the snowflake, attach a piece of thread, yarn, ribbon, invisible thread or wire.
The stiffening solution will permanently damage your pins, so it’s best to set the used ones aside for use in future starching projects.