Crochet Snowflake Milos
Update your tree this Christmas with pretty white snowflakes. This snowflake motif is very easy, it takes very little time so make a bunch and give to friends and family as gifts.
For this snowflake, I used cotton thread size 10 and a 2 mm crochet hook. Its final size is 8 cm (about 3 inches) in diameter. You can use heavier thread and bigger hook, or thinner thread and smaller hook and you will have a bigger or smaller motif.
You will also need a needle to weave in loose ends and a pair of scissors.
In order to stiffen the snowflakes you will need white pva glue or your favorite starch, stainless steel pins (or toothpicks), plastic wrap and some kind of foam/blocking board.
AD-Free, Print Ready PDF version of this pattern is available here.
Make a magic ring.
- Round 1: Ch 1, 6 sc in the ring, pull the thread end to tighten the ring and join with sl st in first sc.
- Round 2: Ch 3 (counts as dc), 1 dc in same stitch, ch 4, (2 dc in next sc, ch 4) 5 times, join with sl st in 3rd ch of first ch3.
- Round 3: Sl st in next st and in ch-4 sp, ch 3 (counts as dc), 2 dc, ch 5, 3 dc all in the same ch-4 sp, * in next ch-4 sp work (3 dc, ch 5, 3 dc); repeat from * 5 times, sl st in 3rd ch of first ch3.
- Round 4: * Ch 2, into next ch-5 sp work (2 dc, ch 3, dc in 3rd ch from hook, 2 dc, ch 6, 2 dc, ch 3, dc in 3rd ch from hook, 2 dc), ch 2, sl st in sp between 2 3-dc groups; repeat from * around.
Fasten off and weave in loose ends.
You will need white pva glue or your favorite starch, stainless steel pins (or toothpicks), plastic wrap and some kind of foam/blocking board.
Print out this blocking template . It will help you make your snowflakes symmetrical. Tape it on your blocking board and then cover it with plastic wrap.
Prepare a mix of equal amounts of white craft glue and water or use your preferred stiffening solution.
Soak the snowflake in the solution, squeeze out the excess and spread out the snowflake on the plastic wrap-covered foam/blocking board, having right side facing up. Use stainless steel pins and start by pinning the center. Work your way out pinning as you go until you reach the desired look. While it is still wet, you can sprinkle glitter and make it sparkly. Let dry completely. Remove from the board.
To hang the snowflake, attach a piece of thread, yarn, ribbon, invisible thread or wire.
The stiffening solution will permanently damage your pins, so it’s best to set the used ones aside for use in future starching projects.